ComputerTrak™ 350 seed monitors ComputerTrak™ 350 seed monitors ComputerTrak 350 The ComputerTrak 350 monitors use electronic circuitry, radar distance measuring and a large liquid crystal display to provide sophisticated monitoring with simple operation. Along with this, the ComputerTrak 350 can monitor up to 32 rows simultaneously. The ComputerTrak 350 monitor solution is available as an optional feature for the following planter models: Drawn planters Integral planters 1750 Planter Series 1700 Planter Series 1760 Planter Series 1710 Planter Series 1760NT Planter Series 1720 8-Row and 12-Row Planters 1770 Planter Series 1730 Planter Series 1780 Planter Series All other planter configurations will only have SeedStar™ 2 monitoring system available with no option for the ComputerTrak 350 monitoring system. ComputerTrak 350 features include:. Population adjustment allows a fudge factor to be used to adjust the displayed population for situations when the calculated population is not being correctly displayed NOTE: ComputerTrak 350 monitors require a radar input. Radar is ordered separately from monitor. In the event of a radar or radar input failure, the ComputerTrak 350 monitor has the capability to continue with the monitoring of seed flow. If a dist-failed message occurs on this monitor, a set speed, or known as speed-set mode, can be entered to allow continued operation until the radar or radar input error has been resolved.

• John Deere Monitor Plug

John Deere Monitor Plug

When in speed-set mode, fast average, area, and speed readouts will not be available. Row-failed messages will occur when seed count drop below two seeds per second. High- and low-population warning messages are also deactivated in this mode. Also while in speed-set mode, the monitor is going to show fluctuating populations because it assumes the machine is traveling at a constant speed, even though actual populations may remain accurate at slower and faster speeds. Displayed population will only be close to actual populations when actual ground speed matches set speed. To enter speed-set mode, please follow the following steps:.

Press the scan switch to being monitoring of seed flow. If power is lost to monitor for any reason, hold the split on/off switch for one second while powering monitor on to re-enter speed-set mode. Previously entered speed is stored in memory and will not have to be re-entered. NOTE: The speed-set mode is deactivated each time monitor is powered off.

Last Updated: 18-May-2011 Product features are based on published information at the time of publication and are subject to change without notice. All trademarked terms, including John Deere, the leaping deer symbol and the colors green and yellow used herein are the property of Deere & Company, unless otherwise noted.

Products, product features, and other content on this site may only be accurate for products marketed and sold in North America. Engine horsepower and torque information for non-Deere engines are provided by the engine manufacturer for comparison purposes only. Actual operating horsepower and torque will be less.

Refer to the engine manufacturer's Web site for additional information. Copyright © 1994-2017 Deere & Company. All Rights Reserved.